SMOK Novo 4 25W Pod Kit

The SMOK NOVO 4 is a low-wattage, draw-activated pod kit that travels well and comes in several colors. Its internal 800mAh battery recharges over Type-C USB and runs a 0.49” OLED Display Screen that always shows battery level, wattage, coil resistance in ohms and puff count.

Wattage is set with the power button, and an air inlet ring lets you tighten or loosen the draw to match it. The 2mL pod fills from the side, holds its coil by press-fit and snaps onto the device with strong magnets. It is suited to nicotine salt e-liquid.

At a glance

• Size: 93.5mm x 26.5mm x 17.7mm
• Battery: 800mAh integrated, rechargeable
• Resistance range: 0.4-3.0Ohms
• Power: 5-25W
• Voltage output: 0.5-4.0V
• Screen: 0.49” OLED Display Screen
• Pod: 2mL, side-fill with silicone stopper, magnetic connectors, pod detection
• Coils: NOVO 4 Series Coils, press-fit installation
• Body: zinc-alloy chassis
• Protections: Short Circuit Protection, Low Voltage Protection, 8 Seconds Cut-Off

Coils

Two coils are supplied: an L1 Meshed 0.8 ohm Coil already installed and a spare LP1 DC 0.8 ohm MTL Coil. Any LP1 NOVO 4 Replacement Coil fits the pod. These coils carry 3 silicone rings along the body as a leak-proof measure, which keeps juice from escaping during a coil change and helps with coil life, flavor and vapor.

What’s in the box

• 1 x NOVO 4 Device
• 1 x NOVO 4 Pod, 2mL, with L1 Meshed 0.8 ohm Coil pre-installed
• 1 x Manual
• 1 x Type-C USB Charging Cable
• 1 x LP1 DC 0.8 ohm MTL Coil

Good to know

The screen shows a message when a protection triggers or when the pod is removed. This is an item for advanced users, used at your own risk. All rechargeable batteries carry an inherent risk in any situation, so take proper precautions, and read the manual until you understand it before you start.